PiZ-EzConnect allows connection to any Raspberry Pi header pins via a terminal block. Like the Pi-EzConnect board, PiZ-EzConnect conforms to the Pi Zero dimensions, making this a nice, compact, easy to use and connect...

Pi-BB-RPS provides Redundant Power Supply capability. Second power is the micro-USB power. Power is switched seamlessly between these two sources. Priority is given to power source with higher power Voltage. DC 5V and 3.3V is generated on the board. The...

Description Three rows in a right angle header!? Yes! These chunks of 0.1″ header has yet-another-row – handy for when you want to connect cables that come in sets of three, like perhaps sensors, or servos. These plug into any standard 0...

Description: High quality general purpose PCB. Material: Single Side Copper PCB. Hole Dia: about 1mm. Hole pitch: standard 2.54mm. For point to point DIY soldering. Size:5cm x 7cm - 1.97inch x 2.76inch. Quantity: 1PC Package Included : 1 X PCB Board

This is a ‘full-size’ breadboard, 830 tie points. Good for small and medium projects. It’s 2.2″ x 7″ (5.5 cm x 17 cm) with a standard double-strip in the middle and two power rails on both sides. You can pull the power rails...

Designed with classrooms in mind, this 10-pack of color-coded alligator clips is ideal for STEM education, science labs, and hands-on electronics learning. These small test leads allow students to quickly connect circuits without soldering—perfect...

Multicolored / comes in a 40-pin separable ribbon cable Great for microcontroller experiment

Handy for making wire harnesses or jumpering between headers on PCB's These premium jumper wires are 20cm long and come in a 'strip' of 40 0.1" male header contacts on one end and 0.1" female header contacts on the other Fit cleanly next to each other on...

This is a cute half-size breadboard, good for small projects. It's 2.2" x 3.4" (5.5 cm x 8.5 cm) with a standard double-strip in the middle and two power rails on both sides. You can pull the power rails off easily to make the breadboard as thin as 1.4"...

Allows two HAT or pHAT (or a mix) to be attached to a single Raspberry Pi 40 way connector. All pins are connected *except* ID_SD and ID_SC (HAT EEPROM) which have solder jumpers – this allows HAT which follow the specification correctly...

The Raspberry Pi 3 Paddle Breakout Kit enables you to bring the Raspberry Pi B+/2/3 GPIO out from your Raspberry Pi to a 'push wire' paddle terminal board! This kit requires absolutely no soldering, but will allow you to jump straight from the Pi to...

A dual row of headers – break to fit. 2x20 pins that can be cut to any size. Dimensions: Upper pin length: 6.0mm Plastic height: 2.5mm Lower pin length: 3.0mm