Octopus TMP36 Temperature Sensor Brick for Arduino and micro:bit is a temperature sensor with low voltage and accurate celsius read. It can provide voltage output,which forms a linear relationship with celsius temperature. TMP36 do not need any external...

OCTOPUS Potentiometer is a simple linear sliding potentiometer electronic building block module which can be used as a resistor divider output, HID control panel, or in the electronic building block kit. News: All of the Octopus bricks support Scratch...

Octopus Electronic Bricks, you can use them to build electronics projects just as easily as piling bricks. By using Octopus electronic bricks, you can connect Arduino/Freaduino compatible boards easily with various digital, analog and I2C/Uart interfaces...

Octopus Electronic Bricks, you can use them to build electronics projects just as easily as piling bricks. By using Octopus electronic bricks, you can connect Arduino/Freaduino compatible boards easily with various digital, analog and I2C/Uart interfaces...

A set of 5 x DS18B20 sensors! This is a digital temperature sensor that can be used with any Arduino board. It measures temperatures from -55°C to +125°C and outputs a digital signal that can be read using one of the digital pins on the Arduino. The...

This is a 5V, 10A 2-Channel Relay interface board. It can be used to control various appliances, and other equipments with large current. It can be controlled directly with 3.3V or 5V logic signals from a microcontroller (Arduino, 8051, AVR, PIC, DSP,...

This is a 5V 8-Channel Relay interface board able to control various appliances, and other equipment with large currents. It can be controlled directly by Micro-controller (Raspberry Pi, Arduino,etc.). Features 5V 8-Channel Relay interface board, each...

5V Four Channel SSR Solid Relay Module 240V / 2A - High Level Trigger - For Arduino Specifications Max. LoadAC: 240V Input Voltage: 5V DC Trigger Current: 2mA Dimensions: 2.28 in x 2.2 in x 0.94 in (5.8 cm x 5.6 cm x 2.4 cm) Weight: 1.34 oz (38 g)

The DHT22 is a basic, low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and spits out a digital signal on the data pin (no analog input pins needed). Its fairly simple...