Built especially to showcase Raspberry Pi's low cost, feature-rich RP2040 chip, this board has VGA output, an SD card slot, digital I2S audio output, and more! Based on the reference design by Raspberry Pi our Pimoroni Pico VGA Demo Base is a great way...

The SparkFun Qwiic pHAT Extension for the Raspberry Pi 400 & 500 provides you with a quick and easy solution to access all of the 400's GPIO, stack your favorite HAT right-side up, or connect a Qwiic-enabled device to the I2C bus (GND, 3.3V, SDA, and...

Compatible with: Raspberry Pi A+/B+/2B/3B/3B+/4B+/Zero This is HiFiBerry DAC2 Pro with a pair of gold-plated RCA jacks. It can be simply plugged onto your Raspberry Pi, without any soldering. HiFiBerry DAC2 Pro is the sucessor of your popular DAC+ Pro...

What is it? APlusCam is designed in the shape of a Raspberry Pi HAT with mounting holes for a Raspberry Pi Camera and suction cups allowing the camera can look out through a window. The original version of this was a PCB, but I've now updated it to...

The ClusterCTRL Stack (controller and passive backplane) is a simple way to both power and control cooling for a stack of 5 Raspberry Pi. Controller Powered by 12-24V PSU. 20 pin header for Power (2x5V and 2xGND for each Pi). 6 pin header for...

Pi Modules - UPS PIco HV3.0B+ HAT Stack 450 PoE - PM_073 The UPS PIco HV3.0B+ HAT Stack 450 PoE is an intelligent UPS and mobile power bank designed for Raspberry Pi 3 Model B+ and fully compatible with the official Raspberry Pi PoE HAT. It...

Please note that due to supply shortages the acyrlic case stock for this product is now solid black instead of transparent black as shown in the product images. This is the VOLT+ With Stepped Attenuator. Includes VOLT+ Amp + Stepped Attenuator + Acrylic...

Waveshare 13890 - 1.3inch OLED Display HAT For Raspberry Pi, 128x64 Pixels, SPI/I2C Interface This is an OLED display HAT for Raspberry Pi, 1.3inch diagonal, 128x64 pixels, with embedded controller, communicating via SPI or I2C interface...

Waveshare 17009 - 2.23inch OLED Display HAT For Raspberry Pi, 128×32 Pixels, SPI/I2C Interface - 2.23inch OLED HAT - 2.23inch OLED HAT This is an OLED display HAT for Raspberry Pi, 2.23inch diagonal, 128×32 pixels, with...

Over one hundred RGB LEDs, all individually-controllable, and four tactile buttons. It's the ultimate pocket-sized rainbow generator for Raspberry Pi! Unicorn HAT Mini is a 17x7 matrix of RGB LEDs that can be controlled, both in terms of...

Waveshare 17372 - 4G/3G/2G/GSM/GPRS/GNSS HAT For Raspberry Pi, Based On SIM7600G-H - SIM7600G-H 4G HAT The SIM7600G-H 4G HAT is a 4G/3G/2G communication and GNSS positioning module, which supports LTE CAT4 up to 150Mbps for downlink data...

The I2C multiplexer allows connecting multiple I2C devices with the same address onto a single I2C bus (PCB colour may vary). For each multiplexed output there are 4 pins - data ports SDAx, SCLx GND ground and V for power. The "V" output can be altered...

Waveshare 3965 - RS232 Communication Board, SP3232 On Board, 3V-5.5V, ESD Enhanced, Hardware Flow Control Supported The RS232 Board is used for establishing RS232 communication with devices powered from 3V - 5.5V. It contains SP3232 (RS-232...

Compatible with: Raspberry Pi A+/B+/2B/3B/3B+/4B/Zero The HiFiBerry DAC2 HD is a high-end DAC for the Raspberry Pi. It can be simply plugged onto your Raspberry Pi, without any soldering. ADDITIONAL INFORMATION Weight 30 g Dimensions 5.5...

Argon Fan HAT for Raspberry Pi 3B/3B+/4B – Active cooling with safe-shutdown button The Argon Fan HAT pairs a 40 mm cooling fan with a built‑in power button for safe shutdown, reboot, and forced-off functionality. It installs in a heartbeat using...

Monitor your world with Enviro + Air Quality for Raspberry Pi! There's a whole bunch of fancy environmental sensors on these boards, and a gorgeous little full-colour LCD to display your data. They're the perfect way to get started with citizen science...

Hey Mr. DJ! Turn up that Raspberry Pi mix to the max with this cute 3W Stereo Amplifier Bonnet for Raspberry Pi. (It's not big enough to be an official HAT, so Adafruit called it a bonnet, you see?) It's the exact same size as a Raspberry...

Take control of and monitor your world with our ultimate jack-of-all-trades Raspberry Pi HAT! We've pulled together a great set of features into this home monitoring and automation controller. With relays, analog channels, powered...

Our HiFiBerry DAC+ ADC combines HifiBerry's well-know DAC+ with an analogue input. Both input and output support sample rates up to 192kHz. Note that you might need to update your Linux kernel to support the audio input features (at least Raspberry...

Waveshare 14972 - 1.3inch IPS LCD display HAT for Raspberry Pi, 240x240 pixels, SPI interface - 1.3inch LCD HAT Overview This is an IPS LCD display HAT for Raspberry Pi, 1.3inch diagonal, 240x240 pixels, with embedded controller,...