8086 Consultancy

This HAT disables WiFi on Raspberry Pi 3B and 3B+ The MMC HAT adds a second micro SD socket to your Raspberry Pi using the second SDIO interface. Please note that the MMC HAT is only officially...

The I2C multiplexer allows connecting multiple I2C devices with the same address onto a single I2C bus (PCB colour may vary). For each multiplexed output there are 4 pins - data ports SDAx, SCLx GND...

Allows four HAT or pHAT (or a mix) to be attached to a single Raspberry Pi 40 way connector. All pins are connected, ID_SD and ID_SC (HAT EEPROM) have cuttable solder jumpers. For HAT/pHAT with an...

Caution! This product is NOT compatible with the new Raspberry Pi Zero W 2 Using solderless pins the adapter slides onto the back of a Pi Zero GPIO (If a permanent connection is required the adapter...

Enables power to a USB device to be turned on/off via a USB power switch (MOSFET). Configuration Supplied with the PD (pull down) resistor set (Normally off). Connectors on top for GND / EN /...

USB Serial Adaptor Plugs directly onto our Cluster HAT and MMC (SD) HAT to provide serial console access to the Raspberry Pi for quick access. Using jumper wires it can be used to access the serial...

USB to (3.3v) Serial adaptor for use with the Raspberry Pi with a pinout designed to plug straight onto Pi GPIO pins (26 or 40 pin). Its a low cost no fuss adaptor which uses built-in USB-CDC...

Dual Supply for Raspberry Pi (A+/B+/2B/3B/3B+) Power from each Micro USB connector goes via a MOSFET "Ideal Diode" which is then connected directly to the Micro USB socket on the Raspberry Pi. Data...

Connect your Raspberry Pi Zero or Pi Zero W directly to your computer for use as a USB Gadget device (USB Ethernet / Serial / Ethernet+Serial / etc.) or just for power. Works with all public...

The Raspberry Pi camera module comes with its own 30cm cable to connect to the Pi, but sometimes that’s simply not long enough. This lovely little board lets you add extension cables to your...

Allows two HAT or pHAT (or a mix) to be attached to a single Raspberry Pi 40 way connector. All pins are connected *except* ID_SD and ID_SC (HAT EEPROM) which have solder jumpers –...

Cluster Hat Version 2.5 The Cluster HAT is also available in a Cluster Kit (comes with 4 Raspberry Pi Zero W) The cluster HAT is physically compatible with the Raspberry Pi Zero 2, but the Zero 2...