Includes 2x DF13 6-pin to 2.54 mm female jumpers for UART and ADC ports 1x DF13 4-pin to 2.54 mm female jumpers for I2C port Wire length: 200 mm

Supports LiPo batteries up to 6S Max current sensing: 60 A* Switching regulator output: 5.3 V 2.25 A 6-pos DF13 cable for connection to Navio2 power port *power module can sense current up to 90A if different connectors are used (XT60 connectors...

This antenna is NOT compatible with NEO-6T USB dongle. Benefits Superior multipath signal rejection Great out-of-band signal rejection Excellent signal-to-noise ratio Consistent response in all op. temperatures Specifications Antenna type:...

Autopilot HAT for Raspberry Pi powered by ArduPilot and ROS Turn your Raspberry Pi® into a drone controller by using the might of sensors and controllers on board. Currently supported boards​ ArduPilot on Navio2 works on: Raspberry Pi 4 Model...

Waveshare 17372 - 4G/3G/2G/GSM/GPRS/GNSS HAT For Raspberry Pi, Based On SIM7600G-H - SIM7600G-H 4G HAT The SIM7600G-H 4G HAT is a 4G/3G/2G communication and GNSS positioning module, which supports LTE CAT4 up to 150Mbps for downlink data...

The VK-162 GPS Receiver is a low cost High sensitivity GPS Receiver + Internal Antenna with USB connector. It is a stand alone GPS receiver providing a solution with high position and speed accuracy performances as well as high sensitivity and tracking...