The adaptor allows the Raspberry Pi 4 to be used with a Pi USB-C power supply (or DC barrel jack) whilst allowing access to USB 2 OTG data over a separate USB-C connection (USB3 data is not connected/passed through). USB Type-C (DATA POWER) <> USB...

The kit contains the following connector boards and pin headers. QtyTypeGender 2 Micro USB Male 2 Micro USB Female 2 USB Type-A Male 2 USB Type-A Female 4 - 6way long pin header Of the 6 pins on the...

The adaptor allows the Raspberry Pi 4 to be used with a Pi Micro USB power supply (or DC barrel jack) whilst allowing access to the OTG USB. USB Type-A (data and power) <> USB Data (Micro USB) and Power (Micro USB/Barrel jack). USB Type...

Caution! This product is NOT compatible with the new Raspberry Pi Zero W 2 Using solderless pins the adapter slides onto the back of a Pi Zero GPIO (If a permanent connection is required the adapter can still be soldered to the GPIO header). The...

Enables power to a USB device to be turned on/off via a USB power switch (MOSFET). Configuration Supplied with the PD (pull down) resistor set (Normally off). Connectors on top for GND / EN / 5V When the EN pin is connected to >2V (5V max) power...

USB Serial Adaptor Plugs directly onto our Cluster HAT and MMC (SD) HAT to provide serial console access to the Raspberry Pi for quick access. Using jumper wires it can be used to access the serial on a Raspberry Pi and for Arduino programming (using...

USB to (3.3v) Serial adaptor for use with the Raspberry Pi with a pinout designed to plug straight onto Pi GPIO pins (26 or 40 pin). Its a low cost no fuss adaptor which uses built-in USB-CDC drivers on most modern operating systems (Win10/Linux/Mac OS...

If you're looking to make a custom cable with any two of Adafruit's HDMI adapters, then you'll need to have these flex cables handy! Making custom HDMI cables has never been easier. Just grab one of these cables, then swap and switch any of the...

If you love DIY cable-rigging, then these HDMI adapters are right up your alley! Making custom HDMI cables has never been easier. Just grab an HDMI ribbon cable, then swap and switch any of our HDMI adapters on each end using the flex cable clips...

If you love DIY cable-rigging, then these HDMI adapters are right up your alley! Making custom HDMI cables has never been easier. Just grab one of our HDMI ribbon cables, then swap and switch any of our HDMI adapters on each end using the flex cable...

Caution! This switch is NOT compatible with the Raspberry Pi 4B. Please see the Type-C Power Switch for Raspberry Pi 4 instead. Add a power switch to any USB-powered project simply by plugging this between the USB power port and the USB cable. This...

If you have a project where you’d like to be able to detach the wiring, this wire will fit the bill. Its a JST 2.5mm ‘free hanging’ cable assembly that latches strongly. One wire is marked with a white dashed line. You can’t plug...

If you have a project where you’d like to be able to detach the wiring, this wire will fit the bill. Its a JST 2.5mm ‘free hanging’ cable assembly that latches strongly. One wire is marked with a white dashed line. You can’t plug these in backwards. We...