8086 Consultancy

Allows four HAT or pHAT (or a mix) to be attached to a single Raspberry Pi 40 way connector. All pins are connected, ID_SD and ID_SC (HAT EEPROM) have cuttable solder jumpers. For HAT/pHAT with an...

Enables power to a USB device to be turned on/off via a USB power switch (MOSFET). Configuration Supplied with the PD (pull down) resistor set (Normally off). Connectors on top for GND / EN /...

USB Serial Adaptor Plugs directly onto our Cluster HAT and MMC (SD) HAT to provide serial console access to the Raspberry Pi for quick access. Using jumper wires it can be used to access the serial...

USB to (3.3v) Serial adaptor for use with the Raspberry Pi with a pinout designed to plug straight onto Pi GPIO pins (26 or 40 pin). Its a low cost no fuss adaptor which uses built-in USB-CDC...

Dual Supply for Raspberry Pi (A+/B+/2B/3B/3B+) Power from each Micro USB connector goes via a MOSFET "Ideal Diode" which is then connected directly to the Micro USB socket on the Raspberry Pi. Data...

Connect your Raspberry Pi Zero or Pi Zero W directly to your computer for use as a USB Gadget device (USB Ethernet / Serial / Ethernet+Serial / etc.) or just for power. Works with all public...

The Raspberry Pi camera module comes with its own 30cm cable to connect to the Pi, but sometimes that’s simply not long enough. This lovely little board lets you add extension cables to your...

Allows two HAT or pHAT (or a mix) to be attached to a single Raspberry Pi 40-pin header. All pins are connected *except* ID_SD and ID_SC (HAT EEPROM), which have solder jumpers –...

Cluster Hat Version 2.5 by 8086 Consultancy The Cluster HAT interfaces a (Controller) Raspberry Pi A+/B+/2/3/4 with up to 4 Raspberry Pi Zeros (1.1/1.2 or W) configured to use USB Gadget mode, and...