Super Slim Raspberry Pi Zero Case
This super slim acrylic case for Zero and Zero W is the minimalist ideal. Sleek and slim with only the bare essentials. All ports can be accessed, including the microSD slot and the camera cable connector, but the PCB is protected enough by the case to handle it safely while powered. Laser-engraved symbols identify the micro-USB and micro-USB power ports.
Only Zero and Zero W boards without header pins will fit this case. Once the header pins are installed, the super slim case cannot be used. There is also no space for a processor heat sink, but the Zero and Zero W run very cool and don't usually need them.
Protective paper covers the glossy black acrylic until you assemble it, and some patience is required to remove it with your fingernails or other non-scratching object. A small jeweler's screwdriver (Phillips) is recommended to tighten the tiny screws.
Zero and Zero W boards without header pins
Two laser-cut acrylic plates, 4 hex standoffs, 8 screws
69 x 33 x 11mm (2.7 x 1.3 x 0.43in)