Adafruit

Design your own Pi HAT, attach custom circuitry and otherwise dress your Pi Zero, A+, B+, Pi 2 or Pi 3 (any Pi with a 2x20 connector) with this jaunty prototyping HAT kit. To kick off the Adafruit...

Connect your own PCB to a Raspberry Pi with this normal-height female header.  The female header part is about 8.5mm tall, good for small HATs that do not to clear the USB/Ethernet jacks. This...

Tiny little servo can rotate approximately 180 degrees (90 in each direction), and works just like the standard kinds you're used to but smaller. You can use any servo code, hardware or library...

Oh so adorable, this is the tiniest little lipo charger, so handy you can keep it any project box! It's also easy to use. Simply plug in the gold plated contacts into any USB port and a 3.7V/4.2V...

NOTE: This product is only designed for use with Adafruit solar panels. We cannot guarantee this will work with solar panels purchased elsewhere. A 2.1mm adapter cable is also required to adapt a...

If we could eat headers we’d have them for breakfast, lunch, and dinner. But we can’t : ( So we’re making the best of it and selling them! This 2×20-pin strip,...

The Raspberry Pi is a wonderful little computer, but one thing it isn’t very good at is controlling DC Servo Motors – these motors need very specific and repetitive timing pulses to set...

Caution! This switch is NOT compatible with the Raspberry Pi 4B. Please see the Type-C Power Switch for Raspberry Pi 4 instead. Add a power switch to any USB-powered project simply by plugging...

Type a description for this product here...

Hey, listen up! It’s the world’s smallest USB microphone! OK maybe it’s not in the Guinness Record Book, but it is pretty darn small! This plug-and-play Mini USB...

Adafruit case for Raspberry Pi Model B+ / Pi 2 / Pi 3. This enclosure was designed by Mike Doell - just like our elegant, beautiful, and functional Pi Case for Raspberry Pi Model B.  Made...

If you're looking for the most compact li'l display for a Raspberry Pi (most likely a Pi Zero) project, this might be just the thing you need! The Adafruit 128x32...

This enclosure was designed by Mike Doell – just like Adafruit’s elegant, beautiful, and functional Pi Case for Raspberry Pi Model B+ / Pi 2.  Made of ultra-durable,...

This is a connector that fits directly to the edge contacts of a BBC micro:bit. The connector has 80 pins, but because of the different widths of the micro:bit edge contacts, some of the micro:bit...

If you have a project where you’d like to be able to detach the wiring, this wire will fit the bill. Its a JST 2.5mm ‘free hanging’ cable assembly that latches strongly. One wire is...

If you have a project where you’d like to be able to detach the wiring, this wire will fit the bill. Its a JST 2.5mm ‘free hanging’ cable assembly that latches strongly. One wire is marked with a...

Make your own USB connections without slicing apart a USB cable and soldering those thin wires inside. These DIY “USB shells” are available in USB A plug, micro B, mini...

Description Three rows in a right angle header!? Yes! These chunks of 0.1″ header has yet-another-row – handy for when you want to connect cables that come in sets of three, like perhaps...

The Microsoft Internet of Things Pack for Raspberry Pi 3 is the best way to get started using Windows 10 and your Raspberry Pi as an IoT enabled device. A collaboration between...

Little clicky switches are standard input "buttons" on electronic projects. These work best in a PCB but can be used on a solderless breadboard. The pins are normally open (disconnected) and when the...